Table of Contents
Advertisement
For overhead use, always install a safety-rope that can hold at least 12 times the weight of
the fixture. You must only use safety-ropes with quick link with
th
rough the hole in the mounting-bracket and over the trussing system or a safe
fixation spot. Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already has held the strain of a crash or which is defective may not be
used again. Adjust the desired inclination-angle via the mounting-bracket and tighten th
screws.
7
. Operation
1. Plug
power cord into a grounded electrical outlet. Turn the power switch on rear of unit
to the "ON" position.
2. The machine will begin producing foam as soon as it is turned on. To stop the foam,
turn the power switch to the "OFF" position.
Important: Always monitor tank fluid level during operation.
Running a foam machine without fluid can permanently damage the
If
you experience low output, mechanical noise or no output at all, unplug immediately.
Check fluid level, the external fuse, remote connection, an
th
e above appears to be O.K., plug the unit in again. If you are unable to determine the
cause of the problem, do not simply continue pushing the remote button, as this may
damage the unit. Return the machine to your dealer.
8. Maintenance
Do not allow foam liquid to become contaminated. Always replace the caps on the liqu
containe
r and the snow machine liquid tank immediately after filling.
B
efore storing, flush out system with clean water.
Foam Liquid
F
ill with Varytec Foam Liquid or other dealer-recommended high-quality water-based
snow or foam fluid. Any other types of fluid can damage the unit.
Save these instructions.
7 / 9
screw cap. Pull the safetyrope
d power from the wall. If all of
e fixation
unit.
id
Advertisement
Table of Contents
