Varytec VF - 120 User Manual page 6

The installation of the device has to be built and constructed in a way that it can hold 10
times the weight for 1 hour without any harming deformation.
When rigging, derigging or servicing the device staying in the area below the installation
den.
place, on bridges, under high working places and other endangered areas is forbid
The operator has to make sure that safety-relating and machine-technical installations are
approved by an expert before taking into operation for the first time and after change s
before taking into oper ation another time.
The operator h as to make sure that safety-relating and machine-technical installations are
approved by an expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical ins tallations are
approved by a skilled person once a year.
Proced ure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, includ ing
(but not limited to) calculating working load limits, installation material being used, and
periodic safety inspection of all installation material and the device. If you lack these
qualifications, do not attempt the installation yourself, but instead use a professional
structural rigger. Improper installation can result in bodily injury and or damage to prop erty.
The device has to be installed out of the reach of people.
ional trussing systems
If the device shall be lowered from the ceiling or high joists, profess
have to be used. The device must never be fixed swinging freely in the room.
Caution: Devices in hanging installations may cause severe injuries when crashing down!
If you have doubts concerning the safety of a possible installation, do NOT install the
device!
Before rigging make sure that the installation area can hold a minimum point load of 10
times the device's weight.
Mount the device to your trussing system using an appropriate clamp.
6 / 9