Danger Of Explosion; Unpacking And Inspection; Operation - Varytec VN 1000 dmx, Gezir 1000 dmx User Manual

Table of Contents

Advertisement

Available languages

Available languages

Danger of Explosion

Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid.
Use only high-quality, water-based fog liquid that your dealer recommends. Other fog liquids may cause
clogging or "spitting".
Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause damage
to the pump as well as over-heating of the heater.
If your VARYTEC VN 1000 dmx, Gezir 1000 dmx Fog Machine fails to work properly, discontinue use
immediately. Drain all fog liquid from the tank, pack the unit securely (preferably in the original packing
material), and return it to your VARYTEC dealer for service.
Always drain tank before mailing or transporting this unit.
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin or
eyes, rinse thoroughly with water.
Note: Pay attention to all warning labels and instructions printed on the exterior of your VARYTEC Fog
Machine
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.
The shipping carton should contain the following items:
1. One unit of VN 1000 dmx, Gezir 1000 dmx Fog Machine
2. Power cord
3. Z-10 Remote Control
4. User Manual
5. Mounting brackets with washers/screws (for VN 1000 dmx)
If any equipment is missing contact your VARYTEC dealer immediately.
Before beginning your initial setup on VARYTEC VN 1000 dmx, Gezir 1000 dmx Fog Machine, make sure that
there is no evident damage caused by transportation. In the event that the unit's housing or cable is damaged,
do not plug it in and do not attempt to use it until after contacting your VARYTEC dealer for assistance.
Setup
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
Place fog machine on a flat surface and remove fog liquid tank cap.
Fill with high-quality, water-based fog liquid recommended by VARYTEC dealer. Any other types of fluid
can damage the unit resulting in spitting and serious clogging problem. When filled, place cap back on
liquid tank. Be careful not to exceed the maximum fluid level. DO NOT OVERFILL.
Firmly attach the remote control cable to the proper input on the back of the machine.

Operation

Add fluid carefully to the liquid tank. Do not overfill the tank.
Plug power cord into a grounded electrical outlet. Turn the power switch to "ON" on the back of the
machine. The unit will take a couple of minutes to warm up the heater. During this time the machine
cannot generate fog. When the remote control is attached the red lights and green light (on the remote) will
flash and stay ON when the warm-up time is complete.
To emit fog press the button on the remote (if it is connected) and on the handle for the desired length of
time.
For further information on operating your VARYTEC VN 1000 dmx, Gezir 1000 dmx Fog Machine, see the
section titled "Remote Control Operation".
Important:
Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can
permanently damage the unit.

Advertisement

Table of Contents
loading

Table of Contents