Table of Contents
Advertisement
4. Unpacking and Inspection
Open the shipping carton and verify that all equipment necessary to operate the system
has arrived intact. Accompanying the S-120 foam machine should be a hanging bracket
and fluid tank. If any equipment is missing contact your dealer immediately.
Before beginning your initial setup on the Foam Machine, make sure that there is
no evid
ent damage caused by transportation. In the event that the unit's housing or cable
is
damaged, do not plug it in and do not attempt to use it until after contacting your
deale
r for assistance.
5. Setup
1. Remove all
packing materials from shipping box. Check that all foam and plastic
padding is removed, especially
2. Place the machine on
3. Fill with Varytec Foam Liquid or other dealer-recom
snow or foam fluid. Any other types of fluid can damage the unit. When filled, place
cap back on liquid tank.
6. Installation
The Foam Machine may be installed at floor
Foam machine in a well-ventilated area. Never cover the unit's vents. In order to
guarant
ee adequate ventilation, allow a free air space of at least 20 cm around the sides
and top
of the unit. Install the device out of
be spilt during operation around the device. The resulting slippery surface can cause
acciden
ts. Position output of foam aw
1.5 m. Only install the machine on scratch resistant and water resistant surfaces.
Please make sure that the inclination angle does not exc
This device is constructed for a standing
overhead, the following safety instructions are binding:
The installation of the device has to be built and constructed in a way that it can hold 10
times the w
eight for 1 hour without any harming deformation.
This de
vice is constructed for a standing installation only. If the device is to be installed
overhea
d, the following safety instructions are binding:
in the nozzle area.
a flat surface and remove the liquid tank cap.
level or suspended overhead. Install the
the public area. Please consider that liquid may
ay from persons. The minium distance should be
installation only. If the
5 / 9
mended high-quality water-based
eed 15°.
device is to be installed
Advertisement
Table of Contents
