Toshiba RAV-SM561AT-E Service Manual page 67

No. Part name
„
Inverter 1) Perform works of items of 1 of
assembly
2) Disconnect connectors connected from
*(Note 1)
Unlock the lock of housing part, and then
disconnect the connectors.
3) Cut the tie lap fixing various lead wires to
4) Remove the rubber sheet and noise-proof
5) Remove terminal cover of the compressor
6) Pull upward the hook (Rear left) with the
Procedure
ƒ
and .
the cycle P .C. board to other parts.
CN600: TD sensor (3P: White)
CN601: TO sensor (2P: White)
CN604: TE sensor (2P: White) *(Note 1)
CN605: TS sensor (3P: White) *(Note 1)
CN301: Outdoor fan (3P: White) *(Note 1)
CN300: Position detection (5P: White)
CN500: Case thermo (2P: Blue) *(Note 1)
CN700: 4-way valve (3P: Yellow) *(Note 1)
CN702: PMV coil (6P: White) *(Note 1)
the inverter assembly.
plate (upper).
and Comp. lead wire.
partition board as if removing it.
• Caution when attaching inverter
assembly
When installing the inverter assembly to
the partition board, attach hook (Rear
left) of the partition board surely.
 ‚
, 1 of ,
There is a hook with the
partition board at rear side.
– 67 –
Remarks
Cycle P.C. board Inverter assembly
Rubber sheet Noise-proof plate
(Upper)
Comp. lead