Error Mode Judgment By Led Display Of Outdoor Unit - Toshiba RAV-SM561AT-E Service Manual

8-3. Error Mode Judgment by LED Display of Outdoor Unit

There provided Dip switch (SW801) and LED on the "Application Control Kit" (TCB-PCOS1E) sold separately for
SM56 and SM80 models, and on the outdoor unit P .C. board for SM110 and SM140 models respectively.
The status of the outdoor unit at that time can be known by switching this Dip switch. The lighting status of LED
also notifies the judged stage before the outdoor error has been determined and displayed on the remote
controller. An error of the outdoor temp. sensor (TO) may be confirmed only by LED display according to the
indoor unit to be combined.
Model Dip SW
SM56, 80 SW01
*
SM110, 140
SW802
(MCC-1531)
Bit 1 Bit 2
OFF OFF
ON OFF
OFF
ON
l
¡
: Go on : Go off
For Models ROA-AP40 to AP80, the error mode judgment by the above LED display is available under condi-
*
tion which "Application Control Kit" (TCB-PCOS1E) sold separately is connected.
(Note)
Never touch part other than Dip switch of "Application Control Kit" (TCB-PCOS1E).
AC230V is applied to all the electronic products, so an electric shock may be caused.
D01 (Red)
D800 (Red)
²
l
ON
Add 16 pulses
if this LED goes on.
Add 256 pulses
if this LED goes on.
ON
The total pulse counts equivalent to lighting LED at each position represents PMV
opening degree. For example, the case of
4 bit) represents 256 + 32 + 4 + 2 = 294 pulses.
²
¥
: 1Hz-flash
LED
D02 (Yellow)
D801 (Yellow)
For error display, refer to
(Table A) on the next page.
During timer short
l
During pump down operation
²
Protective operation count
In normal time, Count 1
Count 2, Count 3
Count 4, Count 5
Count 6, Count 7
Protective operation
PMV opening data (Lower 4 bit data)
Add 8 pulses
if this LED goes on. if this LED goes on.
PMV opening data (Upper 4 bit data)
Add 128 pulses
if this LED goes on. if this LED goes on.
¡
: 5Hz-flash
– 34 –
D03 (Yellow) D04 (Yellow)
D802 (Yellow) D803 (Yellow)
l
²
l l
During backup
l
¡
l
¡
¡ ¡
² ²
Add 4 pulses Add 2 pulses
if this LED goes on.
Add 64 pulses Add 32 pulses
if this LED goes on.
ll ll
¡ ¡¡
(Upper 4 bit, Lower
l
²
control
¥