Aiphone AX Quikstart Manual page 4

4) Time-Out
Step 1: Set Call-in time for door stations
from 10 to 600 seconds or to infinite if
the call is to ring until it is answered.
(Set for both Normal and Priority Calls)
Step 2: Set the duration of an All Call
announcement from 10 to 600 seconds.
(Set for both Normal and Priority Calls)
Step 3: Set the CO Transfer time from
10 to 300 seconds for how long a CO
transferred call will ring the outside
telephone line.
Step 4: Set the Communication time
for the maximum amount of time
allowed for an intercom conversation
(30 to 600 seconds). Set the CO
Communication time for the maximum
amount of time allowed for a CO
transferred call (30 to 600 seconds).
Step 5: Set the Door Release Relay
setting for the duration of time that
the contacts are to be activated.
5) CO Transfer
Step 1: If using the CO Transfer
feature, click on the Enable
button. If not, skip to section 6,
Communication Method.
Step 2: If Reverse Polarity
Detection is required for your
phone line, click on Detect. This
is sometimes required, depending
on the phone line.
Step 3: The wait time for Ring-
Back-Tone can be adjusted from
1-60 seconds.
6) Communication Method
Step 1: The Communication Method
can be switched from "VOX or Press-to-
Talk" to "Press-to-Talk" only. If "Press-
to- Talk" is selected, the hands-free VOX
feature will be disabled on all master
stations.
AX Quikstart Guide
Pg. 4
Step 6: Set the Door Station
Monitor for the amount of time that
you want to be able to listen in to a
door station (10 to 600 seconds).
When a door station is selected, the master
will be in listen mode for this length of time,
then will time out..
Step 7: Set the Door Station Scan
Monitor for the amount of time that
you want to listen to each door
station while in Scan Monitor mode
(5 to 60 seconds).