Establishing The Connection To The Remote Control - Revox Joy Symphony User Manual

Configuration

Establishing the connection to the remote control

The first step -
Once all connections are in place, the
Symphony can be connected to the
mains
After switching on, the green
LED on the front panel flashes for about
10 seconds. Pairing
Symphony and an S208 remote control
can be carried out during this green
phase. In the case of a combi-package
consisting of Symphony and S208 remote
control, Revox will already have carried
out the pairing. You can switch the
Symphony on directly by pressing the
hotkey on the remote control with the
name Symphony. In the example on the
right, that would be hotkey A.
Carrying out a pairing with a new S208
With a new S208 Remote control without
pairing, the pairing process is started by
unplugging the Symphony from the
power source and waiting until the
status LED on the front panel has gone
out. If you now connect the Symphony to
the power again, the LED flashes green
for about 10 seconds. You should confirm
Start pairing by pressing th e OK button
on the S208 during this green-LED phase.
Now, the S208 tries to connect to the
Symphony. If one is recognised, it
transmits its name to the S208. This can
now be edited and assigned at a later
stage to a hotkey. This successfully
completes the pairing process and the
Symphony is automatically switched on.
status

between the
If the battery icon is already visible
on the S208 or if there is no display at all,
the battery needs to be charged - see
Charging the battery
Chapter
Symphony
.
25