Display Colours: Status Led - Revox Joy Symphony User Manual

Symphony

Display colours: Status LED

Dark-blue

Quickstart function [off]:
In this standby mode, all functions,
with the exception of the RF module,
are deactivated.
Power consumption: < 0.6 W
A deactivated quickstart mode [off]
does not support the USB input for
charging external devices, e.g. an
iPhone.
Light-blue

Quickstart function [on]:
Unit is in standby mode. If the
Quickstart function is activated, the
network processor is switched on
permanently. This significantly reduces
the switch-on
connection to the network doesn't
have to be built up again. All other
sub-assemblies, such as the audio
signal processing or the outputs, are
switched off, as with normal standby
mode. Quickstart mode is also a
requirement, in order to be able to
control the receiver with a network-
based Revox App S232 (Apple)/ S235
(Android).
Power consumption: approx. 4.5 W*
The USB input supports the charging
of external devices, e.g. an iPhone in
quickstart mode [on].
* without USB feed
10
phase, as the
Green (flashing)

After plugging in the power cord, the
status LED flashes green for about 10
seconds. During this time, the S208
remote control
synchronised with the Symphony, i.e.
these two devices can be connected
with each other, functionally. You will
find the necessary steps for this
procedure explained in the
Remote control
Software-Update
The green status LED flashes during
a software update, whether via USB
or over the Internet.
Red (flashing)

A non-defined fault has occurred. If
necessary, briefly disconnect the device
from the mains.
Red (permanent)

The timer in the Symphony is active. This
can be the case, for example, if the timer
function is activated, with which the
Symphony switches itself on automatically
after a certain time.
White 
The Symphony is in operation.
Presentation
can be paired/
S208
chapter.