How To Replace The Power Cord - Panasonic TH-47LFT30W Service Manual

2. Undo the two screws to remove the main switch board
from the metal holder fitting and replace it with the
replacement board. (SCR BIN+SW+W3X6)
3. Undo the two screws to remove the RC LED board from
the metal holder fitting and replace it with the replacement
board. (SCR BIN+SW+W3X6)

8.20. How to replace the power cord

When replacing the power cord, the power cord has to be
detached from the bottom of the cabinet back.
1. Remove three ferrite cores which are fitted on the power
board side of the power cord. Take care not to damage
the power cord when cutting the CV band with nippers,
etc.
2. Turn to loosen the waterproof nut which secures the
power cord onto the cabinet back and remove the nut.
3. Pull the power cord out of the hole in the waterproof nut.
4. Undo the waterproof nut using a spanner to disassemble
it.
5. Open the slit of the rubber packing which is located inside
the waterproof nut to remove the rubber packing from the
power cord.
6. Pull the waterproof nut off the power cord.
7. Fit the CV band in a position which is 550 mm from the
power board side connector, on the replacement power
cord.
29
TH-47LFT30W