How To Remove The Handles; How To Replace The Av Cover (Bottom); Position For The Hook Holds Cables; How To Replace The Cabinet Back - Panasonic TH-47LFT30W Service Manual

8.22. How to remove the handles

Take the following steps to change the handles when the han-
dle gets damaged, etc.
1. Undo the screws shown in the drawing to remove the
handle from the back plate together with the metal holder
fitting. (SPECIAL SCREW 4X10)
2. Undo the screws shown in the drawing to remove the
handle from the metal holder fitting. (SPECIAL SCREW
5X12)
When replacing the handle with replacement part, reuse
the existing metal holder fitting because the metal holder
fitting is not a replacement part.
8.23. How to replace the AV cover
(bottom)
1. Undo the ten screws to remove the AV cover (bottom)
from the back plate. (SPECIAL SCREW 4X12)
2. Replace it with the replacement AV cover bottom (bot-
tom).
The replacement AV cover (bottom) is a single unit part
including gasket and gel for the wire outlet.
8.24. Position for the hook holds
cables
The position for fitting the hook for holding cables, etc. is as
shown in the drawing of the metal fitting A and B for the chassis
base.
8.25. How to replace the cabinet
back
1. Remove the main switch board, RC LED board, and the
power cord from the cabinet back.
2. Undo eight screws to remove the metal panel holder fit-
tings. (SCR BIN+SW+W 4X10)
3. Replace it with the replacement cabinet back.
31
TH-47LFT30W