Removing The Air Filters; Removing The Air Supply Fan And Exhaust Fan; Removing The Back Plate - Panasonic TH-47LFT30W Service Manual

• The replacement AV cover is a single unit part including the
warning label and gel for the wire outlet.
8.7.

Removing the air filters

1. Remove the two hooks fixed on the top and bottom of one
side to open the filter cover.
2. Undo the two decorative screws fixed on the side, and
remove the air filter together with the holder to horizon-
tally.
Precautions for replacing the air filters
• The air filter functions for the inlet and outlet of air differ
greatly. If they are fitted incorrectly, they can allow dust to
enter the main display unit. Always fit them correctly.
• Remove the air filters in a horizontal direction according to
the procedure described above.
Forcibly opening the filter cover to remove it will result in
damage to the unit.
• Cleaning air filters is required, because dust and dirt builds
up in air filters during use.
Clean any dust and dirt adhering to the air filters, and around
the unit, using a vacuum cleaner. Take care not to damage
the air filters while cleaning them.
8.8. Removing the air supply fan
and exhaust fan.
1. Remove the screws which hold the finger guard and fan
together. (SCR PAN+SW+W 4X50, 4 screws per part, 6
parts)
2. Remove the coupler of the fan.
3. Remove the fan and finger guard.
Precautions for replacing the fan
The air inlet fan and air outlet fan face different directions
when fitting them. If they are placed incorrectly, they will not
perform their functions of moving air in or out. Always place
them correctly.
8.9.

Removing the back plate

1. Remove the fan. Remove the coupler for the fan and tem-
perature sensor, and tuck the cable into the hole that the
fan has been removed from.
23
TH-47LFT30W