Installation; Television Location; Optional Cable Connections; Ac Power Supply Cord - Panasonic SuperFlat CT-F3394 Operating Instructions Manual

Installation
INSTALLATION
Television Location
This unit is intended to be used as part of an entertainment center. Consult your dealer for
available options.
Avoid excessive sunlight or bright lights, including reflections.
O Keep away from excessive heat or moisture. Inadequate ventilation may cause internal
component failure.
Fluorescent lighting may reduce remote control transmitting range.
fl Keep away from magnetic equipment, including motors, fans and external speakers.
Optional Cable Connections
Shielded audio and video cables should be used between components. For best results:
0 Use 75-ohm coaxial shielded cables.
0 Use appropriate input and output connectors that match your component connectors.
0 Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT
USE A PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
FOR SOME MODELS THAT ARE NON-POLARIZED, THE USE OF AN AC
ADAPTOR CONNECTOR MAY BE NECESSARY.
Cable / Antenna Connection
Forproper reception, e ithera cableor antennaconnectionis required.
Cable Connection
Connect the cable supplied by your Iocal_ cable company to ANT1
connection on back of television. Select cable mode and ANT1 in SET UP
menu under Prog Chan (Program Channels).
Note: A cable converter box may be required for proper reception.
Check with your local cable company for compatibility
requirements.
Polarized plug
Incoming Cable from
Cable Company
75 OhmVHF/UHF
onbackofTV
Antenna Connection
• For proper reception of VHF/UHF channels, an external
antenna is required. For best reception, an outdoor
antenna is recommended.
• Connect home antenna to ANT1 connection on back of
television. Select TV mode and ANT1 in the SET UP menu
under Prog Chan.
Incoming Cable from
Home Antenna
Cable Mode is preset at the factory.
Antennausersmustchangeto TV mode and
selectANT1 in the Set Up Menu under Prog =
I Chen.
E!