CONNECTING THE MONITOR AND TUNER
Connecting the monitor and Tuner
Connect the signal output (SIGNAL OUT) socket on the rear panel of the Tuner to the
signal input (SIGNAL IN) socket on the monitor using the connecting cable.
Precaution:
The connecting cable and the signal inputs and outputs on the monitor and on the rear panel of
the Tuner are specifically designed for this product. Do not connect any other devices or cables.
Connect the cable before connecting the power adapter. If you need to disconnect the cable,
first disconnect the power adapter.
Attaching the cable cover
After connecting the cables, please attach the cable cover to the rear of the monitor in order to
protect the cables.
1
Insert the three tabs on the upper side
of the cable cover into the holes of the
connection section on the rear of the
monitor.
Removing the cable cover
Remove the cable cover by pulling it downward in the middle of the lower section.
Precaution:
Please make sure that the cable cover does not trap any of the cables.
8
2
Slide the two sides of the lower part of
the cable cover into position until they
audibly click into place.