Appendix - Delfi DelfiScan C70 Programming Manual

Condensed DataWizard
PROGRAM
Family Code Selection
Replacer Control
st
1 Replacement
nd
2 Replacement
rd
3 Replacement
The Data Replacer is used to edit the scanned raw data prior to transmitting the data to the host computers or
terminals. It allows you to select desired bar code symbologies for replacer control, and provides Multiple Position
Replcement in the identified position.
All data must conform to the Identified Bar Code Symbologies, and one to three Identified Characters in the
identified position While the Data Replacer is enabled, it arranges only scanned data without Preamble, Postamble,
STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record Suffix.
Regarding the "Bar Code Selection" and "Position Calculation" of Data Replacer, please refer to page 37 for details.
Please note that all "Character" input should be referred to the ASCII/HEX Table listed in Appendix to find mathced
HEX value.
Data Replacer Setting
P.C Parameter Selection
SS Disable
MS Select one bar code symbology
Select all bar code symbologies
MS
SS Disable
Enable
DS
2-digits identified position; 1 replacement
character
SS Disable
Enable
DS
2-digits identified position; 1 replacement
character
SS Disable
Enable
DS
2-digits identified position; 1 replacement
character
M_DEFAULT
Option
2nd Option Code
Code
FIN
automatic termination
(2 digits)
automatic termination
00
FIN
[00-7F]
(2 digits)
position
FIN
[00-7F]
(2 digits)
position
FIN
[00-7F]
(2 digits)
position
40