Setting Option Setup Method; Setting An Indoor Unit Address And Installation Option - Samsung AJ009JNNDCH Service Manual

4-2 Setting Option Setup Method

4-2-1 Setting an indoor unit address and installation option

Setting Option
Entering mode for
Setting Option
1. Remove batteries from the remote controller
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button.
3. Each time you press Low Fan button, 7-seg on left side is increased by "1" and each time you press High Fan button,
7-seg on right side is increased by "1"
4. You press button to move to the next setteing page.
5. After setting option, press
6. Press operation button
EX) Set the each option separately since you cannot set the ADDRESS setting and indoor unit
installation setting option at the same time.
Samsung Electronics
(AJ***JNN/JNA***)
setting option
High Temp Button
Low Temp Button
button to check whether the option code you input is correct or not.
with the direction of remote control for set.
Option
setting mode
Mode change
High Fan Button
Low Fan Button
4-7