Figure 61. SAS connectors on the hot-swap hard disk drive backplanes
1
SATA/SAS signal connector 2
2
SATA/SAS signal connector 3
When connecting the ThinkServer RAID 500 Adapter to the hot-swap hard disk drive backplanes using the
mini SAS cable, connect the mini SAS connector
7
,
8
, and
9
to the SAS connectors 0, 1, 2, and 3 on the hot-swap hard disk drive backplanes.
Note: Remove any device that might prevent you from connecting the hot-swap hard disk drive backplanes.
3
SATA/SAS signal connector 0
4
SATA/SAS signal connector 1
5
to the RAID card. Connect the four SAS connectors
.
Chapter 5
Replacing FRUs
6
,
95