Table of Contents
Advertisement
The Network Settings window is used to enable or disable DHCP. If DHCP is enabled, the window
shows the values assigned by the DHCP server. If a static IP address is used, enter values for the IP
address, Subnet Mask, Default Gateway, and DNS Server appropriate for your network. If you are unsure
about these values, contact your network administrator.
When data is entered in the E-Mail Settings window, the projector is prompted to send E-mail status
messages to an administrator, such as lamp timer warnings. In most cases the sender and receiver E-mail
addresses are the same. Some mail servers require a sender address, otherwise the E-mail is blocked. If
you are unsure about these settings, contact your network administrator.
6-5
Chapter 6. Remote network operation
Advertisement
Table of Contents
