Table of Contents
Advertisement
Status/# of
LED
Flashes
Power
4
5
6
7
8
9
10
Note: If the projector LEDs flash in a manner that is not addressed above, unplug the power cable and
contact your retailer.
Thermal protector
When the temperature inside the projector becomes abnormally high, the LED indicator flashes red (0.5
seconds on/0.5 seconds off) the Standby indicator is a steady red, and at the same time the temperature
protector operates and switches off the power of the projector. If this happens, please follow the steps
below:
1. Switch off the power and disconnected the power plug from the wall outlet.
2. Check the temperature of the room. If the projector is being used in a location with a high ambient
temperature, set it up in a cooler location.
3. Check the vent openings to make sure that they are all clear. Clean the vent openings if they are
obstructed.
4. Wait at least 1 hour until the temperature of the projector drops, then plug it in again.
5. If you are still having the same problem, please contact your retailer.
Description
System overheating
System interface error
Lamp error
Fan error (refer ready LED status to determine which fan)
Lamp cover open
DLP driver error
Color wheel error
Appendix B. Troubleshooting
B-3
Advertisement
Table of Contents
