Table of Contents
Advertisement
Figure 16. Installing the short rubber mounts
10. To install the new system fan assembly into the chassis, align the open holes
Figure 17. Replacing the system fan assembly
11. Once the system fan assembly is secure, you should remove the extra rubber
12. Connect the system fan assembly cable to the fan connector on the system
13. Replace the heat sink. See "Replacing the heat sink" on page 16.
14. Go to Chapter 4, "Completing the parts replacement," on page 31.
20
Hardware Installation and Replacement Guide
8. Install the two short rubber mounts in the new system fan assembly as shown
in Figure 16.
9. Install the two long rubber mounts into the rear of the chassis. Push the
mounts through the holes of the chassis. If necessary, pull the mounts through
the holes from inside the chassis.
in the system fan assembly with the long rubber mounts in the chassis. Pull
the rubber mounts through the holes in the system fan assembly until the fan
is in place.
from the mounts.
board.
Advertisement
Table of Contents
