Replacing The System Fan Assembly - Lenovo ThinkCentre 8700 Hardware Maintenance Manual

10. Align the drive bay assembly with the two slots and rails on the sides of the
11. Reinstall the front bezel.
12. Go to "Completing the FRU replacement" on page 124.

Replacing the system fan assembly

122
Hardware Maintenance Manual
6. Note the front panel assembly cable routing and remove the assembly from
the chassis.
7. Route the cable for the new front panel card assembly through the hole in the
chassis and to the system board.
8. Install the front panel card assembly into the chassis and secure it with the
screw.
9. Connect the front panel assembly cables to the system board.
chassis and slide the drive bay assembly towards the rear of the chassis until
it snaps into position.
1. Remove cover. See "Removing the cover" on page 87.
2. Remove the front bezel by releasing the three tabs and pivoting the bezel
forward to remove completely.
3. Slide the drive bay assembly forward until the drive bay assembly is aligned
with the two slots on the sides of the chassis. Pull upward on the handle 1
on the drive bay assembly to remove it completely from the computer.