Replacing the mouse
This section provides instructions on how to replace a mouse.
1. Remove any media from the drives, shut down your operating system, and
2. Unplug all power cords from electrical outlets.
3. Locate the connector for the mouse.
Figure 31. Replacing a mouse
4. Disconnect the failing mouse cable from the computer.
5. Connect the new mouse cable to the appropriate connector on the computer.
6. Go to Chapter 4, "Completing the parts replacement," on page 31.
30
Hardware Installation and Replacement Guide
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the ThinkCentre Safety and Warranty Guide that came with your computer.
To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
turn off all attached devices and the computer.
Note: Your mouse might be connected to a standard mouse connector 1 or a
USB connector 2 . Depending on where your mouse is connected, see
"Locating connectors on the rear of your computer" on page 6 or "Locating
controls and connectors on the front of your computer" on page 5.