Replacing The Screws To The Heat Sink And Fan - Lenovo ThinkCentre 7096 Hardware Installation Manual

6. Position the new heat sink on the plastic retention bracket so that the four
Figure 31. Replacing the screws to the heat sink and fan assembly
7. Connect the microprocessor fan cable to the microprocessor fan connector on
8. Go to Chapter 4, "Completing the parts replacement," on page 33.
26
Hardware Installation and Replacement Guide
screws are aligned with the posts on the system board. Tighten the four
screws 1 to the heat sink and fan assembly to the system board.
the system board.