Exmark Turf Tracer Operator's Manual page 30

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
1. Caster Wheel Bearings
2. Caster Pivots
3. Idler Pivots (Mower Deck)
4. Idler Pivot (Pump Drive)
5. Hydro Control Arm
No. 4 (Idler Pivot (Pump Drive))
Located Under Engine Deck
No. 3 & 4 (Idler Pivots)
Disassemble and grease once a
month under a "No Load" condition.
5.1.15
5.1.16
5.1.17
5.1.18
5.1.19
FITTING
LOCATIONS
Support Bushings
Check spark plugs.
Service Interval: 160 hrs.
a) Remove spark plugs, check condition and adjust plug gap or replace with
new plugs. See Engine Owner's Manual.
Remove engine shrouds and clean cooling fins.
Service Interval: See Engine Owner's Manual
a) Stop engine and remove ignition key.
b) Remove cooling shrouds from engine and clean cooling fins. Also clean
dust, dirt and oil from external surfaces of engine which can cause
improper cooling.
c) Make sure cooling shrouds are properly reinstalled. Operating the engine
without cooling shrouds will cause engine damage due to overheating.
Change fuel filter.
Service Interval: As Required
a) A fuel filter is installed in the fuel line between the fuel tank and the
engine. Replace when necessary.
Wheel hub - slotted nut torque specification.
When tightening the slotted nut on the wheel motor tapered shaft:
a) Torque the slotted nut to 100 ft. lbs.
b) Further tighten the nut until the next set of slots line up with the cross
hole in the shaft.
c) Replace cotter pin.
Note: Do not use anti-seize compound on the wheel hub.
Thread locking adhesives such as "Loctite 242" or "Fel-Pro, Pro-Lock Nut-
Type" are used on the following fasteners:
a) Pump drive pulley setscrews.
www.mymowerparts.com
LUBRICATION CHART
INITIAL
PUMPS
12
2
1
2
2
- 25 -
No. of SERVICE
PLACES INTERVAL
2 Daily
2 Daily
2 Weekly
1 Weekly
2 Weekly