Specifications; Model Number; Engine; Fuel System - Exmark Turf Tracer Operator's Manual

Exmark turf tracer walk-behind mowers
Hide thumbs Also See for Turf Tracer:
Table of Contents

Advertisement

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

2. SPECIFICATIONS

2.1 MODEL NUMBER:

2.2 ENGINE

2.2.1
2.2.2

2.3 FUEL SYSTEM

2.3.1
2.3.2
2.3.3
2.3.4

2.4 ELECTRICAL SYSTEM:

2.4.1
2.4.2
2.4.3
2.4.4
2.4.5
2.4.6

2.5 STEERING/BRAKE CONTROL:

2.6 TRANSMISSION:

2.6.1
2.6.2
2.6.3

2.7 WHEEL DRIVE SYSTEM:

Serial No.s 160,000 - 189,999: TT18KC
Serial No.s 160,000 - 219,999: TT22KC
Serial No.s 190,000 - 219,999: TT19KA
Serial No.s 220,000 & Higher: TT23KC
Engine Specifications: See your Engine Owner's Manual.
3600 RPM (No Load).
Capacity: 5.0 gal. (18.9 L.)
Type of Fuel: Regular unleaded gasoline, 87 octane or higher. In countries
using the research method, it should be a 90 octane minimum.
Fuel Filter: Replaceable in-line
Fuel Shut-Off Valve: 1/4 turn
Charging System: Flywheel Alternator
Charging Capacity: 15 amp
Battery Type: BCI Group U1 235 amps at O° F
Battery Voltage: 12 Volt; Polarity, negative ground.
Fuses: blade type, 20 amp to charging circuit; 20 amp to electric clutch.
Safety Interlock System: Operator must have OPC (Operator Presence
Control) levers held in contact with handle grips, transmission in neutral and
blade clutch disengaged to start engine. Release of OPC levers will cause the
engine to stop if hydro transmission is not in neutral and/or blade clutch
is engaged.
Fingertip drive control levers provide independent speed control, braking and
neutral to each drive wheel for moving forward or reverse, stopping and power
turning.
Twin Hydrostatic Drive
Two Hydro Gear BDP-10L series variable displacement pumps independently
coupled to two high efficiency Parker/Ross wheel drive motors.
Hydraulic Filter is replaceable cartridge type.
P/N 513211: 10 microns, 18 psi bypass (Summer use above 32° F)
P/N 523541: 40 microns, 18 psi bypass (Winter use below 32° F)
Speed Range:
Forward
Reverse
Drive wheels are direct coupled to Parker/Ross wheel drive motors with 1.0"
(25.4 mm) tapered shaft.
www.mymowerparts.com
0 - 6.2 mph (10.0 km/h)
0 - 2.2 mph (3.5 km/h)
- 8 -

Advertisement

Table of Contents
loading

Table of Contents