Exmark Turf Tracer Operator's Manual page 25

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.1.1
5.1.2
5.1.3
Check engine oil level.
Service Interval: See Engine Owner's Manual
a) Make sure engine is stopped and on a level surface.
d) Check with engine cool.
c) Clean area around dipstick. Remove dipstick and wipe oil off. Reinsert
the dipstick. DO NOT screw into place. Remove dipstick and check oil
level.
d) If the oil level is low, add oil as specified in the Engine Owner's Manual to
bring the oil level up to the "F" mark on the dipstick. DO NOT
OVERFILL.
IMPORTANT: DO NOT operate the engine with oil level below the "L"
mark or over the "F" mark.
Clean engine air cooling system.
Service Interval: See Engine Owner's Manual
a) Stop engine and remove ignition key.
b) Clean all debris from engine air intake screen and from around engine
shrouding.
Clean grass build-up under deck and check mower blades.
Service Interval: Daily
POTENTIAL HAZARD
♦ Raising the mower deck for service or maintenance
relying solely on mechanical or hydraulic jacks could
be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may not be enough
support or may misfunction allowing the unit to fall,
which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic jacks
for support. Use adequate jack stands or equivalent
support.
a) Disengage electric blade clutch.
b) Stop engine and remove ignition key.
c) Raise deck and block up using proper safety precautions.
d) Clean out any grass build-up from underside of deck and in deck
discharge chute.
e) Inspect blades and sharpen or replace as required.
f) If blade removal is necessary, be careful for the sharp cutting edges of
the blades.
g) Re-install the blades (if they were removed) and torque blade bolts to 75-
80 ft. lbs. Be sure the spring disk washer cone is installed toward the bolt
head (See Figure 5).
h) Remove jack stands (or equivalent support) and lower deck to ground.
www.mymowerparts.com
CAUTION
- 20 -