Exmark Turf Tracer Operator's Manual page 18

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.5.2
3.5.3
3.5.4
3.5.5
3.5.6
3.5.7
3.6
3.7
3.8
3.9
3.10 PERFORM NECESSARY ADJUSTMENTS.
Place battery on a level surface and remove vent caps.
Fill cells with battery grade sulfuric acid (1.265 specific gravity). Fill until
halfway between top of separators and bottom of vent well.
Let battery stand for 1/2 hour after filling. If battery acid level has fallen, refill to
level above plates.
Charge the battery at 4 to 5 amps for 3-5 hours.
After charging, install vent caps and wash off any acid with water and dry
battery.
POTENTIAL HAZARD
♦ If the ignition is in the "ON" position there is potential
for sparks and engagement of components.
WHAT CAN HAPPEN
♦ Sparks could cause an explosion or moving parts
could accidentally engage causing personal injury.
HOW TO AVOID THE HAZARD
♦ Be sure ignition switch is in the "OFF" position.
Install battery in machine and secure battery hold down. Connect cables to
terminal posts, positive(red) cable first, then negative (black) cable. Reinstall
battery cover.
NOTE: If time does not permit charging the battery, or if charging equipment
is not available, follow steps 3.5.1 through 3.5.4 and install as described in
3.5.7. Then run the vehicle continuously for 20 to 30 minutes to sufficiently
charge the battery.
After charging, if battery acid level has fallen, refill battery with clean drinking
water (distilled water is preferred – if available).
SERVICE HYDRAULIC OIL
The machine is shipped with hydraulic oil filled to the top of the baffle in the
reservoir. Run the machine for approximately 15 minutes to allow any extra air
to purge out of the hydraulic system. Check hydraulic reservoir and if
necessary fill the reservoir to the appropriate level with Mobil 1 15W-50
synthetic motor oil.
GREASE UNIT:
NOTE: UNIT IS NOT GREASED AT THE FACTORY.
Refer to Maintenance Section 5.1.14 for grease zerk locations and grease
amounts.
FAMILIARIZE YOURSELF WITH THE CONTROLS.
See Controls Section 4.1.
FOLLOW PRE-START INSTRUCTIONS
See Pre-Start Section 4.2.
See Maintenance and Adjustment Section 5.
www.mymowerparts.com
CAUTION
.
- 13 -