Subaru LEGACY 2001 Service Manual page 19

C: DISASSEMBLY
1. FRONT BUSHING
1) Using ST-A, B, press front bushing out of place.
ST-A, B 20099AE020 INSTALLER &
(1) Set ST-A in position with larger inside diam-
eter side facing up.
(2) Set rear arm with protruded bushing side
facing down.
(3) Place ST-B on upper side of bushing, then
press bushing out of position.
2. REAR BUSHING
Using ST-C and bearing puller, press rear bushing
out of place.
ST-C 20099AE040 INSTALLER & REMOVER
SET
(1) Bearing puller
REAR ARM
S201105A06
S201105A0601
REMOVER SET
B4M1800A
S201105A0602
B4M1801B
D: ASSEMBLY
1. FRONT BUSHING
1) Using ST-A, B, press bushing into trailing link.
ST-A, B 20099AE020 INSTALLER &
(1) Set ST-A in position with smaller inside
diameter side facing up.
(2) Set rear arm in position with outer side of
vehicle body facing down.
(3) Place bushing on upper side of rear arm.
(4) Place ST-B on upper side of bushing, then
press bushing into position.
CAUTION:
¼ Install bushing with painted side facing up.
¼ Install front bushing in the proper direction,
as shown in figure.
(1) Bushing
RS-17
Rear Suspension
S201105A02
S201105A0201
REMOVER SET
B4M1803A
B4M1802B