Subaru LEGACY 2001 Service Manual page 12

Rear Suspension
2. CAMBER
S201116A1002
¼ Inspection
1) Place front wheel on turning radius gauge.
Make sure ground contacting surfaces of front and
rear wheels are set at the same height.
2) Set ST into the center of the wheel, and then
install the wheel alignment gauge.
ST 927380002 ADAPTER
(1) Alignment gauge
(2) Turning radius gauge
NOTE:
Refer to the "SPECIFICATIONS" for the camber
values.
<Ref. to RS-2 SPECIFICATIONS,
Description.>
¼ Front Camber Adjustment
Refer to "FS" section for front camber adjustment.
<Ref. to FS-6 INSPECTION, Wheel Alignment.>
WHEEL ALIGNMENT
3. WHEEL TOE-IN
¼ Inspection
1) Using a toe-in gauge, measure rear wheel toe-
in.
Toe-in:
0±3 mm (0±0.12 in)
2) Mark rear sides of left and right tires at height
corresponding to center of spindles and measure
distance "A" between marks.
3) Move vehicle forward so that marks line up with
front sides at height corresponding to center of
spindles.
4) Measure distance "B" between left and right
marks. Toe-in can then be obtained by the follow-
ing equation:
A − B = Toe-in
B4M0567B
General
¼ Adjustment
1) Loosen self-locking nut on inner side of link
rear.
CAUTION:
¼ When loosening or tightening adjusting bolt,
hold bolt head and turn self-locking nut.
¼ Discard
replace with a new one.
(1)
(2)
2) Turn adjusting bolt head until toe-in is at the
specification.
RS-10
S201116A1003
loosened self-locking
Adjusting bolt
Link rear
H4M1279B
nut and
B4M1785B