Connecting To Your Network; For Further Information - RadiSys ENDURA TP945GM Quick Start Manual

Quick Start Guide
Installing the operating system and drivers
The TP945GM has been tested with the following operating systems. Note that some
devices drivers may not yet be available.
Microsoft Windows XP Professional, SP2
Windows XP Embedded, SP2
Windows Media Center 2005
Windows Vista
Red Hat Enterprise Linux 4.0 AS
Novell SUSE Linux Professional 10.0
Knoppix Linux 5.0.1
1. Install the operating system using a bootable CD-ROM. Follow the installation
instructions provided with the operating system.
2. Download the drivers for the required operating system from the RadiSys Web site.
These are available on the downloads page for the TP945GM motherboard. For
detailed instructions on installing each driver, refer to the Procelerant Endura
TP945GM Mini-ITX Motherboard Driver Installation Guide.

Connecting to your network

The TP945GM motherboard is available with single or dual Gigabit Ethernet ports
based on a Broadcom BCM5789 10/100/1000 Mbps Ethernet controller. Connect to
the network using the RJ45 connectors located on the rear I/O panel. Each RJ45
connector has integrated LEDs to indicate link status and link activity.
PXE Boot and Wake-On-LAN are also supported.

For further information

Be sure to check the RadiSys web site (www.radisys.com) for additional user
documentation, drivers, and other information related to this product.
14