Connecting Video Devices - RadiSys ENDURA TP945GM Quick Start Manual

Quick Start Guide
Connecting font panel devices
The following table gives the pinouts for the front panel I/O header. See
"Motherboard layout: top view"
Configuration
Hard disk LED
20 19
Front panel reset switch 5 & 7
Front panel power
button switch
Front panel yellow LED 4 & 2
Front panel yellow LED
(ALT)
Front panel green LED 2 & 4
Front panel green LED
(ALT)
2 1
Front panel speaker
Front panel intruder

Connecting video devices

The integrated Intel Graphics Media Accelerator (GMA) 950 video controller on the
TP945GM motherboard supports LVDS output at up to 1600 x 1200 32-bit color @
75Hz and RGB analog output at up to 2048 x 1536 32-bit color @ 75Hz. The
motherboard also supports:
PCI Express x16 graphics cards, or Endura Media Expansion Cards
Dual independent displays using any of VGA, LVDS, TV output and Media
Expansion Card interfaces
Composite, S-Video, and Component (YPbPr) TV output
HDTV with 1024 x 768 resolution for NTSL/PAL
12
on page 5 for the location of this header.
Table 1. Front Panel I/O Header
PIN# Pin Name & Description
1 & 3 Pin 1: HDD_LED_Power, 5V power for hard disk LED
Pin 3: HDD_LED#, hard disk read/write activity LED
Pin 5: Ground, ground for FP_RESET# pin
Pin 7: FP_RESET#, reset system input
6 & 8 Pin 6: FP_PWRBTN#, power button input
Pin 8: Ground, ground for FP_PWRBTN# pin
Pin 2: FP_YELLOW#, yellow LED lights when the system is at S3
(standby) or S4 (hibernate) status
19 & 15 Pin 15: FP_YELLOW#, yellow LED lights when the system is at S3 or
S4 status
Pin 4: FP_GREEN#, green LED lights when the system is at S0
(running) status
15 & 19 Pin 19: FP_GREEN#, green LED lights when the system is at S0
status
10 & 12/16 Pin 10: 5V, 5V power for speaker
Pin 12: FP_SPKR, speaker
Pin 16: FP_SPKR, speaker
18 & 20 Pin 18: FP_INTRUDER#, intruder input (case open)
Pin 20: Ground, ground for FP_INTRUDER# pin
Figure 5,