Network; Ide Drives; Diskette Drives; Standard Pc I/O - RadiSys Endura GL815E Product Manual

Table of Contents

Advertisement

2.6

Network

The GL815E supports an optional 10/100 Ethernet controller based around the controller integrated
within the chipset and an Intel GD82562ET transceiver. An RJ45 connector located on the rear
panel integrates two LED indicators to provide link status information. The list below describes the
features provided.
IEEE 802.3 10Base-T and 100Base-TX compatible
32-bit bus-mastering PCI device
Jumper-less configuration
RJ45 with two integral LEDs showing line activity, link integrity and line speed
The operation of the two indicators is described in the table below.
LED color
LED state
Green
Off
On
Yellow
Off
Steady on
Blinking
2.7

IDE Drives

Two independent bus-mastering IDE interfaces are provided, each supporting ATA modes up to
UltraATA/100. The following drive types are supported.
ATA hard disks up to UltraATA/100 speeds
ATAPI devices such as CD-ROMs
LS120 drives
The BIOS supports logical block addressing (LBA) and extended CHS translation modes for hard
disks. When booting from LS120 drives, the correct mode (floppy or hard disk) must be chosen in
Setup. The BIOS supports both automatic and manual determination of ATA cable type (80 - or 40-
pin) to support UltraATA/66 or ATA/100 drives.
2.8

Diskette Drives

The diskette drive interface supports a maximum of two drives. The drives should be 2- or 3-mode
3.5-inch devices supporting 720kB, 1.2MB or 1.44MB formats. The controller is located at I/O
addresses 3F0-3F7h and uses IRQ6.
2.9

Standard PC I/O

The standard PC I/O functions serial ports, parallel ports, keyboard and mouse ports and diskette
drive controller are provided via a National Semiconductor PC87366 Super I/O (SIO) device
attached to the low pin count (LPC) bus from the chipset ICH2. In addition, this device provides
system monitoring and fan control functions and general-purpose I/O lines.
GL815E Endura Motherboard Product Manual
Indicates
10Mbps link speed
100Mbps link speed
No link is established
Link is established but there is no communication activity
Link is established and communication activity is detected
Page 17 of 51

Advertisement

Table of Contents
loading

Table of Contents