NAIM NAP 500 Reference Manual page 11

N A P 2 00
1 2 NAP 2 00 In st allat ion and Oper at io n
The NAP 200 should be installed on a dedicated equipment stand intended for the purpose
and should be in its final location before connecting cables or switching on. Switch on the
source and preamplifier components, with the volume turned down, before switching on the
NAP 200. The NAP 200 power button is located on the front panel.
The NAP 200 can provide power for an appropriate Naim Audio preamplifier. The power
supply output is carried on the DIN input socket.
The NAP 200 is heavy and care should be taken when lifting or moving it. Make sure that the
surface it is to be placed on can support its full weight.
1 2 .1 Ge ne r a l Conne c t ion s Note s
The negative input and output connections are all common.
The mains earth should always be connected regardless of
what other equipment is used. This only grounds the case
and the electrostatic screen within the transformer, and is not
connected to the signal negative. In order to avoid hum loops,
the signal negative of the whole system should be connected to
the mains earth (ground) in one place.
1 2 .2 Protec t i on Note s
If the amplifier's external case reaches 70°C due to prolonged
running at high power, the mains supply will be interrupted and
the illuminated logo will switch off until the amplifier has cooled
down. This may take up to thirty minutes.
1 3 NAP 2 00 Connect ions
1 3.1 NAP 2 00 Rea r
mains input
and fuse
left
speaker
OPERATION OF THE AMPLIFIER'S THERMAL PROTECTION
SUGGESTS PROLONGED USE AT TOO HIGH A VOLUME
LEVEL. YOUR LOUDSPEAKERS MAY BE AT RISK IF THIS IS THE
CASE. THE VOLUME SHOULD BE REDUCED.
12.3 Loudspeaker Cable and Connectors
Only Naim Audio speaker cable should be used to connect a
loudspeaker to the output of the NAP 200. Custom Naim Audio
loudspeaker connectors are supplied to make the connection and
in order to comply with current European safety regulations these
should always be used.
DAMAGE TO THE AMPLIFIER MAY RESULT IF "HIGH
DEFINITION" CABLE OR ANY OTHER SPECIAL CABLE IS USED
TO CONNECT THE LOUDSPEAKERS.
Ensure when connecting speakers that they are "in phase". That
is, the positive and negative connection orientation at both the
speaker and amplifier ends of the cable is the same for both
channels.
right
speaker
E9
signal input
ch1(L) & ch2(R) and
preamp power supply
Input/Preamp
Power Socket
ch1
ch2
24V
0.3A
-ve