Safety Instructions; Environmentally-Friendly Disposal; Scope Of Delivery; Installation Area - Bosch WVH28360GB Installation And Maintenance Instructions Manual

Safety instructions

– The washer dryer is heavy – take care when lifting it.
– Warning: frozen hoses may tear/burst. Do not install the washer dryer outdoors or in areas
where there is a risk of frost.
– The washer dryer may be damaged. Do not lift by moveable components (e.g. washer dryer
door).
– In addition to the instructions mentioned here, special regulations regarding the relevant
water and power supply companies may apply.
– If in doubt, have the appliance connected by a technician.
– Lay hoses and cables in such a way that there is no risk that they can be tripped over.
Environmentally friendly disposal
– Dispose of packaging in an environmentally friendly manner.
– This appliance has been identified in accordance with the European Directive
2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). This directive
specifies a framework for the return and recycling of waste appliances, and is valid
throughout Europe.

Scope of delivery

Aqua-Stop Aqua-Secure
Depending on the connection
– A 24–40 mm dia. hose clip may also be required for connecting the siphon (available from
specialist retailers). Page 4: Water connection
Useful tool
– Spirit level for aligning the washer dryer.
– Wrench for adjusting the machine feet.
Humidity in the drum is caused
according to the model
by the final inspection.
Standard
Elbow
Covers
for fixing the waste
water hose

Installation area

– Stability is important to prevent the machine from wandering.
– The installation area must be firm and level.
– Soft floors/floor coverings are not suitable.
– Ensure the area is well ventilated to achieve good drying performance.
If installing the appliance on a platform
– It is essential to secure the washer dryer feet with holding brackets *.
If installing the appliance on a wooden joist floor
– If possible, install the washer dryer in a corner.
– Screw a water-resistant wooden panel (min. 30 mm thick) to the floor.
– It is essential to secure the washer dryer feet with holding brackets *.
* order no. WMZ 20490, WZ 20490

Hose and cable lengths

Connection on left side
Water drainage
Water supply
Power cord
Note: If hose holders are used, the hose lengths may be reduced.
Available from dealer/after-sales service:
– Aqua-Stop extension hose **, approx. 2.50 m.
– Longer supply hose, approx. 2.20 m, for standard model.
** order no. WMZ 2380, WZ 10130

Built-under/built-in appliances

Build these appliances under/in before connection to the power supply.
Installed in between kitchen units (built-under or built-in)
– 62 cm cavity width required.
– Install the washer dryer only under a continuous worktop that is connected firmly to the
adjacent cupboards.
1
or
Connection on right side
~90 cm
~140 cm
~95 cm ~140 cm
~160 cm ~165 cm
2