Chapter 7 Pci Bus Ethernet Interface; Introduction; Features; Installation Of Ethernet Driver - Intel PCM-9587 User Manual

All-in-one single board computer

Table of Contents

Chapter 7 PCI Bus Ethernet Interface

The PCM-9587 is equipped with a high-performance 32-bit Ethernet

chipset which is fully compliant with IEEE 802.3 100 Mbps CSMA/CD

standards. It is supported by major network operating systems. It is also

both 100Base-T and 10Base-T compatible.

• Intel 82551 10/100Base-T Ethernet LAN controller

• Supports Wake-on-LAN remote control function.

• PCI Bus Master complies with PCI Rev. 2.2

• Complies with 100Base-TX, and 10Base-T applications.

• Single RJ-45 connector gives auto-detection of 10 Mbps or 100 Mbps

network data transfer rates and connected cable types.

• Enhancements on ACPI & APM.

• Complies with PCI Bus Power Management Interface Rev. 1.1,

• ACPI Rev. 2.0, and Device Class Power Management Rev. 1.0.

Before installing the Ethernet driver, note the procedures below. You

must know which operating system you are using in your PCM-9587, and

then refer to the corresponding installation procedure. Then just follow

the steps described. You will quickly and successfully complete the

installation, even if you are not familiar with instructions for Windows.

Note:

PCM-9587 User's Manual

The windows illustrations in this chapter are

examples only. You must follow the flow chart

instructions and pay attention to the instructions

which then appear on your screen.

Table of Contents