Scala KP-6166 Instructions For Use

Introduction
thank you for deciding for the blood
pressure monitor KP-6166 from SCALA.
To be able to utilise all advantages of
the blood pressure monitor to the fullest,
you
instructions before using the monitor.
Keep the instruction leaflet in a safe
place.
Digital Wrist Blood
Safety instructions
Pressure Monitor
The blood pressure monitor KP-6166
KP-6166
enables you to monitor your blood
pressure regularly. However, you should
never change the treatment which your
doctor has prescribed
Self-measurement means monitoring,
it does not imply diagnosis or
treatment.
Discuss
doctor.
Do
prescribed by your doctor.
The heart rate is not a useful indicator of
the frequency of a cardiac pace maker.
Patients with cardiac arrhythmia should
use the blood pressure monitor only
after consulting a doctor.
Features of the KP-6166
- The blood pressure monitor has fuzzy
If the pumping pressure set in the
0197
factory is not sufficient, the device
identifies this and continues pumping.
- The device has 2 selectable memories
each with 50 memory locations.
- Instructions for use -
- The date and time are displayed and
stored together with every blood
pressure value.
- If the battery icon is displayed, the
- The handcuff is suitable for
should carefully read these
Preparing the monitor for measurement
/ changing batteries
Insert the two supplied batteries in the
battery compartment at the side of the
blood pressure monitor as shown. Use
only alkali batteries (LR03).
If the batteries are depleted, the battery
icon
the LC display. The battery needs urgent
replacement because you cannot use the
monitor with depleted batteries.
The LC display
unusual values with your
not change the medication
logic to identify the pumping pressure.
Setting the clock
After you have inserted the two batteries,
you should set the clock. It starts with year
„1/ 1" (for the 1st month / 1st day) and
"12:00" o'clock after every battery change.
- 2 -
batteries are discharged and the
device cannot be used until new
batteries are inserted.
wrists from 135 to 195mm circumference.
is displayed in the lower part of
- 3 -
To set the clock, hold the MEMORY button
pressed for about 5 seconds. The year
blinks in the top left corner of the display.
Set the year with the ON/OFF button.
When the correct year is set, press the
MEMORY button again. Now the 1 blinks
in the top left corner of the LCD. It stands
for the month.
Set the month with the ON/OFF button.
Another press of the MEMORY button sets
another 1 blinking. It stands for the first day
in the month.
Set the day with the ON/OFF button.
Another press of the MEMORY button
takes you to the clock setting – the hours
blink. As earlier, set the clock with the
ON/OFF button.
Pressing the MEMORY button advances to
the minutes setting.
Set the minutes with the ON/OFF button.
A final press of the MEMORY button
completes the setting of the date and time.
How to obtain correct measuring
results
To obtain correct readings,
measure the blood pressure
always under the same
conditions, at rest, not under
the effect of alcohol, not
during meals, not after
heavy physical or mental
stress. If possible, sit down
at a table for the
measurement.
Please note: The blood pressure monitor
must be at heart level during the
measurement, otherwise wrong readings
are obtained.
- 4 -
The measuring method
Put the cuff around your left wrist
making sure that the device rests on the
artery and the top edge of the device is
about 1 cm away from the wrist joint.
The cuff should be applied with
moderate tightness.
Now select "your" memory area with the
select button, which you want to use
and in which you want to store your
blood pressure values by pressing the
MEMORY button. (The BP monitor has
2 different memory areas each with 50
memory locations. The other memory
area can be used by family members or
other persons.)
After you press the button for selecting
the memory area, the word USER 1 is
displayed. Another press of the select
button displays the word USER .
So select "your" USER memory. Then
wait for 5 seconds until the displays
disappears.
- 5 -