Scala SC 6400 Instructions For Use

Digital Wrist Blood Pressure Monitor
SC 6400
GB
Instructions for use
Introduction
Thank you for deciding for the blood pressure monitor SC 6400 from
SCALA Electronic GmbH. To be able to utilise all advantages of the
blood pressure monitor to the fullest, you should carefully read these
instructions before using the monitor. Keep the instruction leaflet in a
safe place.
Safety instructions
The blood pressure monitor SC 6400 enables you to monitor your
blood pressure regularly. However, you should never change the
treatment which your doctor has prescribed
Self-measurement means monitoring, it does not imply diagnosis
or treatment.
.
Discuss unusual values with your doctor
Do not change the medication prescribed by your doctor.
The heart rate is not a useful indicator of the frequency of a cardiac
pace maker.
Patients with cardiac arrhythmia should use the blood pressure
monitor only after consulting a doctor.
Features of the SC 6400
The blood pressure monitor has fuzzy logic to identify the pumping
pressure. If the pumping pressure set in the factory is not sufficient,
the device identifies this and continues pumping.
 The device has 85 memory locations.
 The date and time are displayed and stored together with every
blood pressure value.
 If the battery icon is displayed, the batteries are discharged and the
device cannot be used until new batteries are inserted.
 WHO-Interpretation of blood pressure readings with colored band
(See description at page 5).
 The handcuff is suitable for wrists from 135 to 195 mm
circumference.
Preparing the monitor for measurement / changing batteries
Insert the two supplied batteries in the battery compartment at the side
of the blood pressure monitor as shown.
Use only alkali batteries (LR03).
If the batteries are depleted, the battery icon
top left corner of the LC display. The battery needs urgent
replacement because you cannot use the monitor with depleted
batteries.
Device description
Setting the clock
After you have inserted the two batteries, you should set the clock.
To set the clock, hold the TIME button pressed for about 5 seconds.
is displayed in the
2