Ap Profile Commands Example - ZyXEL Communications ZYWALL USG Series Reference Manual

Chapter 7 Wireless LAN Profiles
Table 12 Command Summary: Radio Profile (continued)
COMMAND
5g-support-speed {disable |
wlan_5g_support_speed}
tx-mask chain_mask
rx-mask chain_mask
[no] htprotection
output-power wlan_power
[no] ssid-profile wlan_interface_index
ssid_profile
exit

7.2.1 AP Profile Commands Example

The following example shows you how to set up the radio profile named 'RADIO01', activate it, and
configure it to use the following settings:
• 2.4G band with channel 6
• channel width of 20MHz
• a DTIM period of 2
• a beacon interval of 100ms
• AMPDU frame aggregation enabled
• an AMPDU buffer limit of 65535 bytes
• an AMPDU subframe limit of 64 frames
• AMSDU frame aggregation enabled
• an AMSDU buffer limit of 4096
• block acknowledgement enabled
• a short guard interval
• an output power of 100%
60
DESCRIPTION
Disables or sets the 5 GHz support rate.
The default is 6.0~54.0.
Sets the outgoing chain mask rate.
Sets the incoming chain mask rate.
Activates HT protection for this profile. Use the no parameter to
disable it.
By default, this is disabled.
Sets the output power for the radio in this profile.
The default is 100%.
Assigns an SSID profile to this radio profile. Requires an existing
SSID profile. Use the no parameter to disable it.
Exits configuration mode for this profile.
ZyWALL / USG (ZLD) CLI Reference Guide