Email Daily Report Commands - ZyXEL Communications ZYWALL USG Series Reference Manual

Table 223 Packet Size Statistics Commands (continued)
COMMAND
show report packet size statistics
{interface_name} [interval interval]
report packet size statistics clear

55.2 Email Daily Report Commands

The following table identifies the values used in some of these commands. Other input values are
discussed with the corresponding commands.
Table 224 Input Values for Email Daily Report Commands
LABEL
e_mail
Use these commands to have the ZyWALL / USG e-mail you system statistics every day. You must
use the
configure terminal
these commands.
Table 225 Email Daily Report Commands
COMMAND
show daily-report status
daily-report
[no] activate
draw-usage-graphics
smtp-address {ip | hostname}
[no] smtp-auth activate
smtp-auth username username password password
no smtp-address
no smtp-auth username
[no] smtp-port <1..65535>
mail-subject set subject
no mail-subject set
[no] mail-subject append system-name
[no] mail-subject append date-time
[no] mail-from e_mail
[no] mail-to-1 e_mail
[no] mail-to-2 e_mail
ZyWALL / USG (ZLD) CLI Reference Guide
DESCRIPTION
Displays the specified interface's packet size distribution statistics. You
can also specify the packet size interval into which to group the
statistics.
interval: 128, 256, or 512 (bytes)
Clears the packet size statistics data for all interface.
DESCRIPTION
An e-mail address. You can use up to 80 alphanumeric characters, underscores (_),
periods (.), or dashes (-), and you must use the @ character.
command to enter the configuration mode before you can use
DESCRIPTION
Displays the e-mail daily report settings.
Enters the sub-command mode for configuring daily e-mail
reports settings.
Turns daily e-mail reports on or off.
Has the report e-mail include usage graphs.
Sets the SMTP mail server IP address or domain name.
Enables or disables SMTP authentication.
Sets the username and password for SMTP authentication.
Resets the SMTP mail server configuration.
Resets the authentication configuration.
Sets the SMTP authentication port. The no command deletes
the setting.
Configures the subject of the report e-mails. Spaces are
allowed.
Clears the configured subject for the report e-mails.
Determines whether the system name will be appended to the
subject of the report e-mails.
Determines whether the sending date-time will be appended
at subject of the report e-mails.
Sets the sender e-mail address of the report e-mails.
Sets to whom the ZyWALL / USG sends the report e-mails (up
to five recipients).
See above.
Chapter 55 Reports and Reboot
367