Private Branch Exchanges / Suppl. Services - Amplicomms Powertel 50 Alarm Plus Operating Instructions Manual

6 Private Branch Exchanges / Suppl. Services

R button on private branch exchanges
If the telephone is connected to a private branch exchange, functions such
as transferring calls and automatic call back can be used via the R button.
Please refer to the operating manual supplied with your private branch ex
change to determine which recall (Flash) time must be set in order to use
these functions. The dealer where you purchased the exchange can pro
vide information as to whether the telephone will work properly with the ex
change. Setting the recall time . Page 12
Dialling pause
In the case of private branch exchanges, it is necessary to enter an access
code to get an outside line with its corresponding dialling tone. When us
ing some older private branch exchanges, it takes a little time before the
dialling tone becomes audible. Particularly in the case of such private
branch exchanges, it is possible to insert a dialling pause after the number
for the outside line so that the number can be dialled in a continuous pro
cess without having to wait for the dialling tone.
£
After dialling the number for the outside line, the telephone then waits
approx. 3 seconds before dialling the actual phone number.
The pause can also be entered with the phone number in the
phone book.
R button and supplementary services
Your telephone supports the supplementary services offered by your tele
phone network provider, such as brokering, call waiting and conference
calls. The supplementary services can be used in conjunction with the R
button. Please contact your telephone network provider regarding which
recall time must be set to use the supplementary services. Please contact
the telephone network provider with regard to enabling the supplementary
services. Setting the recall time . Page 12.
2
Insert a dialling pause.
P" is shown in the display.
Service-Hotline: Tel. 0844 800 6503
Private Branch Exchanges / Suppl. Services
1
Caller number display (CLIP )
If this function is available with your telephone line, the number of the
caller appears in the display when the phone rings. If the caller has sup
pressed transmission of his phone number, a corresponding message ap
pears in the display. The phone number is not displayed and, as a result,
is not stored in the calls list.
The caller number display function is an optional service offered
by telephone network providers. Contact your network provider
for further information.
1
CLIP: Calling Line Identification Presentation
11