Battery Replacement; Connect Batteries - Tripp Lite SmartPro Owner's Manual

Battery Replacement

Under normal conditions, the original batteries in your UPS will last many years. See Safety
section before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the
UPS in ON mode), but some qualified service personnel may wish to put the UPS in the OFF mode
and disconnect equipment before proceeding.
Remove Front Panel
1
Disconnect Batteries
2
Remove/Dispose of Batteries
3
Add Batteries
4

Connect Batteries

5
Attach connectors: black-to-black and red-to-red.
Replace Front Panel
6
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series
number. The series number can be found on the product nameplate label, along with all required approval markings and information.
When requesting compliance information for this product, always refer to the series number. The series number should not be
confused with the marking name or model number of the product.
WEEE Compliance Information for Tripp Lite Customers and Recyclers (European Union)
Under the Waste Electrical and Electronic Equipment (WEEE) Directive and implementing regulations, when customers
buy new electrical and electronic equipment from Tripp Lite they are entitled to:
• Send old equipment for recycling on a one-for-one, like-for-like basis (this varies depending on the country)
• Send the new equipment back for recycling when this ultimately becomes waste
Tripp Lite follows a policy of continuous improvement. Product specifications are subject to change without notice.
Made in China.
Note on Labeling
Two symbols are used on the label.
V~ : AC Voltage
V : DC Voltage
Procedure
12
1
 2

3
6
5
4