Quick Installation - Tripp Lite SmartPro Owner's Manual

Quick Installation

Insert a user-supplied power cord
1
(with country-specific plug) into
the UPS System's IEC-320-C20
AC input receptacle. Plug the
cord into an AC wall outlet.*
NOTE! after you plug the UPS into a live AC outlet,
the UPS (in "Standby" mode) will automatically
charge its batteries,** but will not supply power to
its outlets until it is turned ON.
* See the UPS system nameplate for input requirements.
** The BATTERY CHARGE LED will be the only LED illuminated.
Find one of the C13-to-C14 power
2
cords that came with the UPS.
Insert the cord's female plug into
your computer's AC input. Insert
the cord's male plug into any UPS
female output receptacle.
Plug your equipment into the
3
UPS.*
Plug your equipment into the UPS. Repeat the previous
step, using the additional power cord(s) included with
the UPS system.
Note: Additional interconnection cords (C13-to-
C14) are available from Tripp Lite. Call
+1.773.869.1234 (Part # P004-006).
* Your UPS is designed to support computer equipment only. You will
overload the UPS if the total VA ratings for all the equipment you
connect exceeds UPS output capacity. To find your equipment's VA
ratings, look on their nameplates. If the equipment is listed in amps,
multiply the number of amps by 230 to determine VA. (Example:
1 amp × 230 = 230 VA). If you are unsure if you have overloaded your
UPS's outlets, see "OUTPUT LOAD LEVEL" LED description.
4
Turn the UPS ON.
Press and hold the "ON/OFF/STANDBY" button for
one second. The alarm will beep once briefly after one
second has passed. Release the button.
1
2
3
4
5