Sharp XL-DV50H Operation Manual page 43

To stop the ASPM operation before it is complete:
Press the ASPM button whilst it is scanning for stations.
The stations which are already stored in memory will be kept there.
Notes:
! Any station which has the same frequency as one stored in mem-
! If 40 stations have already been stored in memory, the scan will
! If no stations have been stored in memory, "END" will appear for
! If the RDS signals are very weak, station names may not be
To erase all of the contents of preset memory:
1
2
! After performing this operation, all of the preset memory informa-
Downloaded From Disc-Player.com Sharp Manuals
ory will not be stored.
be aborted. If you want to redo the ASPM operation, erase the
preset memory.
about 4 seconds.
stored in memory.
Press the ON/STAND-BY button to enter the stand-by mode.
Whilst pressing down the TUNER (BAND) button and the 2 but-
ton, press the ON/STAND-BY button until "TUNER CL" appears.
tion will be erased.
To store a station name again if the wrong name was stored in
memory:
It may be impossible to store station names in memory using the
ASPM function if there is lots of noise or if the signal is too weak. In
this case, perform as follows.
1 Press the PRESET ( or ) button to check whether the names
are correct.
2 If you find a wrong name during receiving the station, wait until the
correct name will be displayed. And then press the MEMORY but-
ton.
3 Within 5 seconds, press the MEMORY button whilst the preset
channel number is flashing.
! The new station name has been stored in memory correctly.
Notes:
! The same station name can be stored in different channels.
! In a certain area or during certain time periods, the station names
may temporarily be different.
" Notes for RDS operation
If any of the following events occur, it does not mean that the
unit is faulty:
! "PS", "NO PS" and a station name appear alternately, and the
unit does not operate properly.
! If a particular station is not broadcasting properly or a station is
conducting tests, the RDS reception function may not work prop-
erly.
! When you receive an RDS station whose signal is too weak,
information like the station name may not be displayed.
! "NO PS" or "NO PTY" will flash for about 5 seconds, and then the
frequency will be displayed.
04/3/19 XL-DV50H(A).fm
XL-DV50H
1
2
3
4
5
6
7
8
9
10
43
TINSEA027SJZZ