Metrologic MS2020 Stratos Installation And User Manual page 98

T
ROUBLESHOOTING
Symptom
RS232 Only
The host is
receiving data but
the data does not
look correct.
Characters are
being dropped.
Aux Port Operation With Any Interface
The secondary
scanner is not
functioning.
The secondary
scanner powers
up but data is not
relayed to the
host.
* Use MetroSet.
For the auxiliary interface, choose "HoloTrak Decode"
All remaining parameters will be automatically chosen.
92
Possible Cause(s)
The scanner and host
may not be configured
for the same interface.
The intercharacter delay
needs to be added to
the transmitted output.
Cable ( 54-54667)
MLPN
may not be connected
to the proper port.
The auxiliary com port
may not be operating
properly.
Solution
Check that the scanner and
the host are configured for
the same interface.
Add some intercharacter
delay to the transmitted
output by using the
MetroSelect Configuration
Guide ( 00-02407B).
MLPN
Refer to the user's guide
provided with the secondary
scanner.
Ensure that the secondary
scanner is connected to the
MS2020 com port marked
"Aux" port.
* The MS2020 series must
be programmed to enable
the auxiliary port.
The auxiliary input port's data
format must match the main
output format of the
secondary scanner.