Abbott FreeStyle Navigator II User Manual page 6

Initial Setup
Charging the Receiver
Before using your FreeStyle Navigator II System for the first time, you
MUST fully charge the Receiver's battery for at least 6 hours . Do not
disconnect the Charging Cable from your Receiver until it is fully
charged . = fully charged = not fully charged
= completely depleted
CAUTION: Do NOT check your blood glucose while charging your
Receiver .
Connect one end of your Charging Cable to an
electrical outlet with the A/C Wall Charger
or to a powered USB Port, such as on a
computer . Connect the other end
of the Charging Cable to your
Receiver . To fully charge the
battery, charge the Receiver for
at least 6 hours . Charging Cable, Receiver,
and A/C Wall Charger
A fully charged Receiver battery
typically lasts approximately 3 days .
Battery life may be shortened if you activate the display frequently . The
number of alarms you receive may also shorten battery life .
Upon disconnecting from the Charging Cable, the Receiver completes
a sequence of self-checks . If the display is turned on, the Receiver emits
tones, vibrates and flashes screen checks during this time . If the Receiver
7
ART22683-101_rev-B.indd 7-8
can detect that any portion of the self-test fails, the Receiver displays a
message on the screen to contact Customer Care .
Setting Time and Date
To turn the Receiver On, press the Power button .
TIME / DATE
--- : --- ---
--- ---, ---
Push scroll wheel
to set time
Accept Accept
CURRENT TIME
Minute = --
Push scroll wheel Scroll up or down
to select "Hour" to select hour
Accept
CURRENT TIME
Minute = --
Push scroll wheel to con rm
and repeat for "Minute"
Accept
CURRENT TIME
Minute = 28
Accept
TIME / DATE
09 : 28
--- ---, --- --- ---, ---
Accept
CURRENT DATE
Day = --
Year = --
Push scroll wheel Scroll up or down Push scroll wheel to
to select "Month" to select month con rm and repeat
for "Day" and "Year"
Accept
CURRENT DATE
Day = 06
Year = 2012
Accept
Note: It is very important that the time and date are correctly set. The
accuracy of the graphs and statistical reports depends upon the date
and time being correct.
Setting Time and Date Format
If you need to change your time and date format settings, follow the
instructions below:
Menu ➞ Settings ➞ Time & Date ➞ Format
12 May 2012 MAIN MENU
320
Insert
Add Event
and
Status
Connect
180
to a new
Settings
Sensor
Manual Cal
40
Home Select
Graph 16:12 Menu
SETTINGS
Time & Date
Display
Glucose Targets
Self Test
Home Select
TIME & DATE
16:14
18 May 2012
Format Done
FORMAT
Date = Day / Month
Accept
8
1/7/15 11:43 AM