2-4
Getting Start
1. Place the Wireless Subscriber Gateway and AG-200E Printer on a flat work surface.
2. Connect the Ethernet cable to the Wireless Subscriber Gateway's LAN port.
3. Connect the other end of the Ethernet cable to the AG-200EAccount Generator Printer's RJ45 port.
4. Ensure that your modem and computer are both switched on.
5. Use the supplied cable to connect
the Wireless Subscriber
Gateway's WAN port to the modem.
Check that the Cable/xDSL Status LED lights.
6. Connect your computer to one of the 10/100 LAN ports on
the Wireless Subscriber
Gateway. Check
that the LAN Port Status LED lights.
7. Configure the further parameters via a Web browser.
Figure 2-4 Wireless Subscriber Gateway Connection
Easy Hotspot Kit
15