Care And Operation - Lennox Hearth Products Montage 32FS Installation And Operation Manual

CARE AND OPERATION

Simple Operating Instructions
. Preparation
a] Check hopper and remove
any materials from hopper
and auger
b] Check UltraGrate™ for proper
fit (ensure UltraGrate is set
securely in the base - see
Figure 29)
c] Check door gasket and door
latch to ensure tight seal
(see Figure 33)
d] Connect power cord to
grounded power supply
outlet
COMBUSTION
Heat Output
AIR
Button O
(-) (+)
HEAT
Convection
OUTPUT
(room air)
Blower
Button
BLOWER
FEEDING
HEARTH PRODUCTS
FIRST TIME USE
3. Priming the Auger
(Optional)
a] Fill hopper with pellets
Note: use quality grade pellet
fuel
b] Push the "START" button
to turn on the blowers and
auger motor
e] When pellets begin to
drop from feed tube into
UltraGrate, push the "STOP"
button to stop the auger
4. Stove is now ready for
start-up
Start Button
START
PELLET
FEED
O
(-) (+)
STOP
Stop Button
1. Start
5. To Start Your Stove
a] Push the "START" button.
Note: Room air blower and
exhaust blower start w/ line
voltage for 10 seconds, then
return to settings when last
operated.
6. Pellets will drop into
UltraGrate and stove will
light in approximately 3
to 7 minutes
Does the Stove Light?
No
7a. Follow the troubleshooting
section in this manual
Does the Stove Light?
No
Contact your Lennox Hearth
Products dealer for further
assistance
7. Set stove to desired
heat setting (heat output
button). The new setting
will not take effect until the
switch receives adequate
heat to activate.
8. After approx. 5 minutes
adjust damper if neces-
sary to obtain a bright
vibrant flame.
Notes:
• If the damper is too far
inward the flame will be
lazy/sooty and the fuel will
pile up in the UltraGrate
Yes
(see Page 9).
• If the damper is too far
outward the flame might
be extinguished because
of too much combustion
air.
See Page 19 for further
instructions on adjusting
damper using thermostat vs
manual modes.
9. To Turn Off Pellet Stove
a] Push "STOP" button - stove
enters shut down mode
Yes
b] Combustion blower goes to
high and room air blower will
operate at the panel setting
until low temperature switch
cools. Pellets stop feeding
and the fire goes out in
approximately 15 minutes
after the auger is shut off, the
room air blower and exhaust
blower will automatically
shut off.
10. Thank you for purchasing a Lennox
Hearth Products Pellet Stove
END
17