Summary of Contents for Lennox Hearth Products MONTAGE 32FS
Page 1
QUICK START GUIDE - MONTAGE™ PELLET STOVE 32FS WARNING Before you set up or operate your stove, review all safety, installation, and operation instructions in your “Installation and Operation Manual.” USING THIS GUIDE This guide contains 5 easy steps to help you learn more about using your new Montage pellet stove.
MANUAL OPERATION* STARTING THE MONTAGE™ PELLET STOVE COMBUSTION Fill the hopper with pellets COMBUSTION Hopper lid must Make sure the hopper lid is completely closed be closed during operation. Press the “START” button on the control panel to begin the ignition cycle HEAT START HEAT...
Page 3
DAMPER ADJUSTMENT The Montage™ pellet stove is equipped with a damper which is used to fine tune combustion. Although every unit is test burned and calibrated at the factory, periodic adjustment may be necessary at times to compensate for variables such as fuel, venting, altitude, and maintenance intervals. OPENING THE DAMPER Opening the damper increases the amount of combustion air.
Page 4
CLEANING AND MAINTENANCE SCHEDULE (CONTINUED) In addition to the regular maintenance procedures described below, the “Installation and Operation Manual” out- lines yearly service that should be performed by a qualified technician. UltraGrate™ Heat Exchanger The UltraGrate should be checked Keeping the heat exchanger for clinkers prior to operating tubes clean will maximize the the stove.