General Operation; Power On/Off; Auto Shut Off Function; Direct Programme Selection - Sanyo CP14G1(C) Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

-/- -

Power ON/OFF

To switch on or off the TV ;

Press the Mains ON/OFF button.

-/- -

The power of the TV is turned on or off complete-

ly. If no picture appears but the Standby and Power

indicator illuminates, press the POWER ON/OFF

button of the remote control transmitter as the TV

set is in standby mode.

To set the TV to standby mode;

Press the POWER ON/OFF button.

During Standby mode the Standby and

Power indicator illuminates more brightly.

To turn on the TV from the standby mode,

press any of the following button.

POWER ON/OFF button of the remote control

transmitter.

Programme UP/DOWN of the remote control

transmitter or the TV set.

1 to 9, 0 button on the remote control

transmitter.

Important !

Be sure to set the Mains ON/OFF switch to the off

position, if the power failure occurs while viewing.

Auto Shut Off Function

This TV set incorporates the AUTO SHUT OFF

function. Even if the TV is left on after you have

gone to sleep, the TV set changes to the standby

mode within 10 minutes after all broadcasts have

ended.

-/- -

Direct Programme Selection

-/- -

For direct access to select programmes

-/- -

using (0~9) NUMERIC button.

To select programmes position more

-/- -

than 9, press DIGIT button, and then

insert programme position number one

by one.

(Example: for programme position 15,

Press "1" button. Press "5" button.

-/- -

For programme position 125 press the

-/- -

Digit button twice. Press "2" button, press

"5" button. For programme 255, Press the

Digit button 3 times. Press "5" button. Press

"5" button.)

-/- -

OFF 0:10

-/- -

Programme Up and Down

Press the Programme UP (CH

-/- -

to select the next programme position.

Press the Programme DOWN (CH

button to select the previous programme

-/- -

position.

Channel Scanning

Press the CHANNEL SCAN button to search for a

-/- -

programme. The channel positions are automati-

cally scanned, and the channel scanning will stop

at the position where it began. To stop at the posi-

tion you want, press this button again.

CH SCAN

Volume Control

Increase or decrease the sound volume level by

pressing the VOLUME (+ or -) buttons.

RECALL

To display the on screen indications, press

the RECALL/COLOUR SYSTEM button.

Off Timer

On Timer

Sound

-/- -

System

Screen display disappears after about 5 seconds.

Sound Mute

Should you wish to mute the sound (e.g.

While talking on the telephone), press the

SOUND MUTE button. To switch the

sound back on, press the SOUND MUTE

button again or VOLUME (+ or -) button.

-/- -