Table of Contents
Advertisement
General
Operation
Usually the Remote
Control Transmitter
is all that is needed to watch the TV.
Please refer to the illustration
on page 2, whilst reading
these
instructions.
Switching on/off
.To
turn on the TV:
Press Mains
ON/OFF
switch ~.
To turn off the TV:
Press the Power ON/OFF
button
~
on the remote
control
transmitter,
and the TV changes to the standby mode.
During
the standby
mode,
the standby
and power
indicator
illumi-
nates more brightly than during the power–ON
mode.
Press this button to turn off the unit for short periods
of the
time.
To turn on the TV from the standby
mode:
Press one of these button.
T
Power ON/OFF ~
Programme
Selector
~
(except buttons"1
-" and "2-")
L
Programme
Selector
~
TO cut off the mains power
completely:
Press the Mains
ON/OFF
switch ~.
Important!
Be sure to set the Mains ON/OFF
switch O to the
off position,
if the power failure occurs while view-
ing.
AUTO
SHUT
OFF
This TV set incorporates
the AUTO SHUT OFF function.
Even if the TV is left on after you have gone to sleep, the
TV set changes
to the standby
mode
within
10 minutes
after all broadcasts
have ended.
Note: AUTO
SHUT
OFF also functions
for the AV mode
even
when there is no signal being transmitted.
The remaining
time for AUTO
SHUT OFF is displayed
on
the screen.
Remaining
time
c
&u
-10
Programme selection
e.g. TO select programme
number
17, press "l-" button and
then press "7" button
~
within five seconds.
To select programme
number
27, press "2-" button and
then press "7" button
~
within five seconds.
Picture and sound adjustments
(Use the remote
control transmitter.)
To adjust the sound volume:
Press A
(up) or Y
(down)
volume ~button.
TO adjust the colour intensity:
Press @ (Colour) button.
+
Press A or ~ volume
button.
To adjust the brightness:
Press ~i
(Brightness)
button.
+
Press A or ~ volume
button.
TO adjust the picture cOtWaSt:
Press ~
(Contrast)
button.
+
Press A or ~ volume
button.
Fine tuning
Press <>
(Fine tuning) button.
+
Press A or ~ volume
button.
<>
1
I
Note: Normally
fine tuning is not required
for this TV. However,
in some case (such as radio interference)
picture may bt=.
come
more
clear by detuning
from the best tuned
fre-
quency.
In such case, you can use this fine tuning
to eliminate
some interference
beat pattern.
To adjust the picture and sound
by using the front controls
of
the TV set:
Select the control function by pressing SELECT button ~.
I
*Each time SELECT button ~
is pressed, the control function
changes as follows;
~SOUND~
@ COLOUR
~-11.
BRIGHT
~~C)NTRAST
Press
Programme
Selector
O
(+
or
-),
and
adjust
the
sound volume,
colour, brightness
or contrast.
TO scan the programmed:
Press the right side ( + ) of the programme
selector ~
of the
TV set, and the TV set will step up to the next station, i.e; 1,2,
3...29,
VCRI,
VCR2, VCR3, 1,2,3
...
Press the left side (–),
and the TV set will step down to the
previous station.
–3–
Advertisement
Table of Contents
